As low as $257.49/mo with or . (Pay in 4 interest-free payments)
The Feuling HP+® Oil System Pack for M8 pairs a High Flow billet camplate, a high volume oil pump and HP+® hydraulic roller lifters to cure the pressure and scavenge problems of the factory oiling system on M-Eight engines. The High Flow camplate is cut from 7075 aluminum, which is 50% harder and stronger than the factory or Feuling® OE+ camplates Larger oil pump reservoirs and passages, with camplate portholes matched to the portholes in the engine case, bring more oil to the lifters, piston cooling jets, crankshaft and rod bearings Each pump is bench tested, its relief valve seated and sealed to a minimum of 30 psi with full pop off at 55-60 psi; a groove on the back cover takes the factory crank bearing seal Scavenge volume goes up 42% and oil volume to the crankshaft and connecting rod bearing goes up 68% Engine temperatures drop 15°-25° and oil temperatures drop 15°-30°, while oil pressure climbs 10-30 lbs more psi Wet sumping, blowby and oily air cleaners are reduced, and test results on M-Eight show a 2 HP and 2 ft/lbs torque gain at the rear wheel The kit contains a billet 6061 aluminum high volume oil pump, the High Flow camplate, HP+® Hydraulic roller lifters, a cam installation kit, cam bearing, cam/crank bolts and washers, and engine and fastener assembly lube On M-Eight engines, clearance between the front exhaust lifter and the camshaft flange must be checked; an optional Feuling® x ARP bolt kit is PART #2401-0993, and those ARP pump bolts take no washers