Gtechniq Auto Crystal Serum Light is a silicon dioxide-based ceramic coating that bonds at a molecular level with your paint's clear coat. It creates a durable, chemical-resistant layer with a high-gloss, professional-grade finish and protection from environmental contaminants. Features: Resists swirl marks and chemicals, including wash chemicals Delivers incredible gloss and depth, enhancing gloss over time Provides up to five years of durability and protection when properly maintained Shields against bird droppings, UV rays, and water spots Resists dirt and tree sap Designed for low-maintenance upkeep and long-term paint protection, keeping the vehicle looking freshly detailed for years Simple steps to help you get the best results: Apply Crystal Serum Light (CSL) indoors, where the vehicle can remain for 12 hours afterward. Do not apply it in direct sunlight. Apply only at a temperature between 5°C and 25°C. Wear gloves and shake well. Before applying, thoroughly wash and decontaminate the paintwork. If necessary, polish by machine or hand to remove imperfections. Start with a ceramic coat to prevent debris from interfering throughout the process. Spray Panel Wipe into a Gtechniq MF1 Microfibre Cloth, then wipe each panel in small sections. Use the pipette to soak the application pad with 3 full measures of CSL, working the liquid into the pad for even saturation. Replace the bottle lid and set the bottle aside. Do not hold it in your hand, as this promotes premature curing. Use overlapping strokes over an area roughly 2ft by 2ft, or work to the vehicle's body lines. Remove residue immediately with an MF1 cloth. You may need to buff the same area several times, but avoid using too much force. Use 2 cloths at any one time and rotate them during residue removal to prevent CSL from curing in the cloth, which can make buffing residue difficult. Use a bright, diffused light source to inspect the surface for residue. If residue is removed and it cures fully, polish the area and reapply CSL. Once finished, put the MF1 cloths in water, then wash and dry them as soon as possible. After applying CSL, wait approximately 2 hours before applying EXO Ultra Durable Hydrophobic Coating or C2 Liquid Crystal. Keep in a cool, dry place. After opening, use within 3 months.