Gtechniq Auto EXOv5 Ultra Durable Hydrophobic Coating shields car paint with a ceramic layer that produces extreme water beading and protects for up to two years. It gives the paint a warm, high-gloss appearance while resisting water spots, road grime, dust and wash chemicals. EXOv5 creates a hard film with anti-static properties that repel dirt particles, so cleaning is needed less often; car wax and standard sealants, by contrast, break down quickly. It withstands UV rays, road salt and environmental contaminants that can corrode surfaces over longer periods. Easy application and a slow flash-off time give you more time to achieve a perfect finish without the pressure of professional application. Apply it alone or over Crystal Serum Light or C1 Crystal Lacquer to enhance durability and swirl mark resistance on easy-to-mark and dark paints. Features: Single-layer application 18-24 months durability Easy to apply Increases gloss while repelling dirt and water. Simple Steps To Help You Get The Best Results: Use EXOv5 on its own as a sealant, or layer it over C1 Crystal Lacquer, Crystal Serum Ultra, or Crystal Serum Light (CSL). For application over C1, finish applying C1 first, then wait a minimum of 4 hours but less than 12 hours before applying EXOv5. When layering over CSL, you can apply EXOv5 straight away, starting where you began with CSL; for best results, wait two hours for a longer flash-off. Keep the vehicle out of direct sunlight and above 5 degrees Celsius (41°F), make sure it is completely dry, and keep it dry for at least 12 hours after application. Wipe every surface with Panel Wipe and an MF1 ZeroR Microfibre Buff Cloth, putting the product on the cloth, not the panel. Omit this step when applying over newly applied C1 or CSL. Shake the bottle thoroughly and put on gloves. Distribute product evenly over the AP2 Ultra Soft Foam Filled Applicator to prime it until the pad is damp. Work over a small panel or half of a large panel using overlapping strokes. Take off residue immediately with an MF1 cloth, buffing the same area several times without excessive force; use a second MF1 afterward to remove smearing. Before the coating gets wet, let it cure for at least 12 hours. After application, leave the car unwashed for at least a week. Store somewhere cool and dry, and use within 3 months of opening.