As low as $207.49/mo with or . (Pay in 4 interest-free payments)
Feuling Parts built this HP+® oil pump around a billet 6061 aluminum high-volume pump, and it ships with a FEULING® High Flow billet camplate. Together they remove the pressure and scavenge trouble that comes with factory oiling systems. Made in the USA. Oil pressure, oil volume, engine oil flow and return scavenging all go up, while the engine runs quieter and smoother Engine temperatures drop by 15°-25° and oil temperatures by 15°-30°, with 10-30 lbs more psi of oil pressure Wet sumping, blow by and oily air cleaners are reduced, and FEULING® test results show up to 50% less engine sump oil level On M-Eight, test results show a rear wheel gain of 2 horsepower and 2 ft/lbs of torque The camplate is cut from 7075 aluminum, 50% harder and stronger than factory or FEULING® OE+ camplates Larger pump reservoirs and critical oil passages, plus camplate portholes matched to the portholes in the engine case, send more oil to the lifters, piston cooling jets, crankshaft and rod bearings Each pump is bench-tested, with its relief valve seated and sealed to at least 30 psi and a full pop-off at 55-60 psi The back cover of M-Eight pumps has a machined groove that takes the factory crank bearing seal A camplate/oil pump fastener kit, PART #2401-0993, can be bought separately. The M-Eight oil pick up port sits on the right side of the engine, so idling or warming up on the kickstand fills the engine case and skews the oil level in the tank